 1 Showing the swingarm carrier plates and cut quality of 1/4" steel straight off the table and after light cleaning, drilling and tapping with M8 x 1.25. |
 2 Video Showing the swingarm carrier plates and cut quality of 1/4" steel straight off the table and after light cleaning, drilling and tapping with M8 x 1.25. |
 3 Showing cut quality on 10 gauge steel straight off of the table. |
 4 Showing cut quality on 10 gauge steel straight off of the table. |
 5 Video showing cut quality and accuracy on 1/2" steel plate with a 1" x 1" square. |
 6 Showing cut quality on some 1/2" steel parts and how any Dross can be easily removed. |
 7 1/2" Steel cut quality with Scribe marked hole locations. |
 8 1/2" Steel cut quality |
 9 1/2" Steel cut quality with Scribe marked hole locations. |
 10 1/2" Steel cut quality |
 11 Closeup of engraving, hole locating and cut quality. This part was taken directly off the table with no cleaning. With a quality torch, good consumables and proper cutting parameters you can get great results with little or no cleanup required. |
 12 Closeup of cut quality. This part was taken directly off the table with no cleaning. With a quality torch, good consumables and proper cutting parameters you can get great results with little or no cleanup required. |
 13 Closeup of cut quality. This part was taken directly off the table with no cleaning. With a quality torch, good consumables and proper cutting parameters you can get great results with little or no cleanup required. |
 14 Showing a Tumbled finish on the left, and a decent clean cut on the right straight off the table out of 10ga (1/8") material. |
