| 1932 Ford Chassis Easy Weld Boxing Plates |
Will fit 32 Fords (all models)
When building a street rod, throwing a modern day V8 motor in older day cars and driving
the higher speeds that we drive today, boxing in the original flimsy frames is a must.
Our Easy Weld boxing plates are cut undersized so that they would basically slip inside the
original frame rails, to allow for a V gap for great weld penetration, without the worry of
grinding away too much weld and sacrificing strength when grinding the welds flush. There
are steps or outward notches incorporated into our boxing plates to prevent them from
slipping inside the frame and making fitting and adjusting difficult.
These are cut from 1/8" (10 gauge) steel to give added strength when welding motor
mounts, crossmembers and etc to the inside of the chassis.
This is a 6 piece set. Our boxing plates are Completely Full Length and fit very accurately,
unlike many others. The fitment was done on American Stamping / Speedway motors
reproduction rails, which are very true to form and will work very well on a stock chassis also.
They run from the front spreader bar to the rear spreader bar with a radius to match them.
Depending on what you want to do in the front or rear section, you can cut off some if you
like, but if you want the entire length boxed, you do not need any extra steel! The outward
notches can also be cut or ground off so that you can slip the plates inside the rails for the
stepped style boxing. This set is very versatile, which allows the builder to pick what he
wants to do. The plates are made in 3 pieces per side for ease of shipping and to reduce
shipping costs.
To state the obvious..some assembly, fitting and welding is required.
When building a street rod, throwing a modern day V8 motor in older day cars and driving
the higher speeds that we drive today, boxing in the original flimsy frames is a must.
Our Easy Weld boxing plates are cut undersized so that they would basically slip inside the
original frame rails, to allow for a V gap for great weld penetration, without the worry of
grinding away too much weld and sacrificing strength when grinding the welds flush. There
are steps or outward notches incorporated into our boxing plates to prevent them from
slipping inside the frame and making fitting and adjusting difficult.
These are cut from 1/8" (10 gauge) steel to give added strength when welding motor
mounts, crossmembers and etc to the inside of the chassis.
This is a 6 piece set. Our boxing plates are Completely Full Length and fit very accurately,
unlike many others. The fitment was done on American Stamping / Speedway motors
reproduction rails, which are very true to form and will work very well on a stock chassis also.
They run from the front spreader bar to the rear spreader bar with a radius to match them.
Depending on what you want to do in the front or rear section, you can cut off some if you
like, but if you want the entire length boxed, you do not need any extra steel! The outward
notches can also be cut or ground off so that you can slip the plates inside the rails for the
stepped style boxing. This set is very versatile, which allows the builder to pick what he
wants to do. The plates are made in 3 pieces per side for ease of shipping and to reduce
shipping costs.
To state the obvious..some assembly, fitting and welding is required.
 |  |  |  |  |
 |
 |
 |
 |
 |
 |
 |
 |
Hold Mouse over picture to see detail
| 1/8" 32 Ford Boxing Plates $200 |
Half Price S/H on additional sets!